


               DECnet-VAX Support Procedures





        This directory contains some command procedures  and
other  information  regarding  DECnet-VAX.  These procedures
should be of use to anyone  attempting  to  start  up  their
network from scratch.



                         CONFIGNET

        Configures   the   local   node,    defines    local
communication  lines,  and then invokes NETBOOT to configure
the remainder of the network.   This  command  procedure  is
very   site-specific   and   dependent   on   the   hardware
configuration of your particular machine.



                          DEFAULT

        Documentation on  the  default  parameters  used  by
DECnet-VAX in configuring the network.



                          LOGIN.*

        Login command procedures for the network manager and
privileged and non-privileged user accounts.



                          NETBOOT

        Defines the characteristics of all the remote  nodes
in  your  network.   This  command  procedure is executed on
every system boot to  reconfigure  the  network  data  base.
This  is  done so that a network manager may simply supply a
new version of NETBOOT to all nodes an be assured that  when
the  particular node is rebooted, then the network data base
will be correctly updated.  This  file  is  site-independent
and  should  be  identical in all nodes in your network.  Of
course, the node names, addresses, and characteristics  will
be different for your network.



                           NETINS

        Command  procedure  to  install  necessary   network
Mostek OPS Spring 1983 SIG Tape Submission            Page 2


directories  and  generate  appropriate  network accounts on
your  system.   This  file  once  modified  to   meet   your
particular   network  requirements,  can  be  migrated  from
machine to machine to  make  clone  copies  of  the  network
throughout the entire VAX network.



                    NETPRT/REMDCL/REMPRT

        Mostek-local DCL network objects to  perform  remote
prints and remote DCL commands via DECnet.



                            NML

        Documentation on switches to enable logging for  the
network management listener
